Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterFurnace Repair in Santa Clarita, CA
Furnace repair in Santa Clarita typically costs between $150 and $450 for most common failures, with the repair guaranteed in writing for a full year. Our techs carry parts for Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard furnaces on every truck, so most calls are completed same-day. If your furnace won’t fire, short-cycles, or blows cold air, call (661) 621-3712 and a real person answers, day or night.
Dalton Heating & Air Santa Clarita handles furnace repair as a core part of our Heating & Furnace in Santa Clarita service. This is not a side trade for us. It’s what our techs do through the coldest stretches of December and January in the Santa Clarita Valley, when overnight lows in Valencia and Saugus dip into the 30s and a dead furnace becomes a real problem, not just a discomfort. Marco Benitez runs this location under The Garrison Standard, which means one thing on paper: the price you’re quoted before work starts is the price you pay. No exceptions.
When You Need Furnace Repair
Some furnace problems are obvious. Others start as small quirks that turn into a no-heat night. These are the calls we run most often across Santa Clarita, Canyon Country, Newhall, and Stevenson Ranch:
- Furnace won’t ignite or start at all. The thermostat clicks, maybe the blower kicks on, but no heat follows. This is a no-heat call and we treat it as a priority.
- Short-cycling. The furnace fires, runs a few minutes, shuts off, then repeats. In Castaic and Valencia where homes sit against the hills, we see this a lot when the flame sensor is coated with carbon buildup.
- Cold air blowing from the vents. The fan runs but the air never warms up. That usually points to a failed ignitor, a bad gas valve, or a tripped limit switch.
- Rattling, banging, or screeching during startup. A high-pitched screech often means a blower motor bearing is on its way out. A bang at ignition can be delayed ignition, which should be checked same-day.
- Gas smell or a furnace that won’t stop running. If you smell gas near the unit, leave the area and call your utility provider first, then call us. A furnace that runs continuously without satisfying the thermostat has a control or airflow issue.
- Rising gas bills with no change in usage. In Santa Clarita’s older tracts around Newhall, underperforming furnaces with dirty burners or failing inducer motors run longer and burn more fuel to hit the same temperature.
If you’re seeing any of these, call (661) 621-3712. We’ll tell you over the phone whether it can wait or needs a same-day visit, and you’ll get a straight answer either way.
Our Furnace Repair Process
Every repair call follows the same sequence. No shortcuts, no skipped steps. It’s how The Garrison Code works in practice.
- Call and diagnosis scheduling. You speak with a live person at (661) 621-3712, 24/7. We set a two-hour arrival window and the tech shows up inside it. You’ll know the tech’s name before they pull up.
- On-site inspection and written quote. The tech tests the furnace, identifies the failed component, and writes up the repair cost before any work begins. That price is firm. If additional issues surface mid-repair, the tech stops and gets your approval in writing before proceeding.
- Repair with parts on hand. Our trucks are stocked with ignition components, flame sensors, gas valves, blower motors, capacitors, and control boards for major brands like Goodman, Rheem, York, and Daikin. Most jobs are completed in one visit.
- Safety check and performance test. After the repair, the tech verifies proper combustion, checks carbon monoxide levels at the vents, and cycles the furnace through a full heat call. We don’t hand the job back until it passes.
- Written guarantee and cleanup. You receive a written guarantee covering the repair for 365 days. The work area is left clean, the furnace panel is back on, and the tech walks you through what was done and why.
If the same repair fails within that year, we return at no charge. Not a service fee, not a diagnostic fee, nothing. That’s the 365-Day Done Right Promise, and it’s included on every repair we do.
Furnace Repair Pricing in Santa Clarita
Most furnace repairs in Santa Clarita run between $150 and $450, depending on the part and the furnace model. Here’s what we see most often:
- Flame sensor cleaning or replacement: $140 – $220. One of the most common repairs in the SCV, especially in high-dust areas near the foothills.
- Ignitor replacement: $180 – $320. Hot surface ignitors fail eventually on every furnace. If your furnace clicks but won’t light, this is often the culprit.
- Blower motor replacement: $350 – $750. Higher on variable-speed units, lower on standard single-speed models.
- Capacitor replacement: $140 – $250. A failed capacitor means the blower or inducer motor won’t start under load.
- Gas valve replacement: $250 – $450. Less common but required when the valve fails to open or regulate gas flow.
- Control board replacement: $280 – $520. When the furnace has power but won’t respond or shows error codes.
- Diagnostic visit (if no repair is needed): $89 – $99. This fee is waived when you approve the repair.
What affects the price? Furnace brand and age matter. A Daikin or Rheem unit from the last decade typically has predictable parts pricing. A 25-year-old furnace with an obsolete control board may cost more or push a replacement conversation. We’ll tell you straight: if a repair is past the point of making financial sense, we say so. You’ll get the repair price and the replacement price side by side in writing, and you decide with real numbers in front of you.
Every quote is free, every price is in writing before work begins, and the repair is guaranteed for a full year. Call (661) 621-3712 to schedule.
FAQs – Furnace Repair
How much does furnace repair cost in Santa Clarita?
Most furnace repairs in Santa Clarita cost between $150 and $450 depending on the part, with common items like flame sensors and ignitors at the lower end and control boards or gas valves at the higher end. We provide a written quote before any work starts, so the price never changes at the door. Call (661) 621-3712 for a free estimate and we’ll give you a solid range over the phone.
Can you fix my furnace the same day?
Yes, in most cases. Our trucks are stocked with parts for Goodman, Rheem, York, Daikin, Carrier, Trane, Lennox, and Bryant furnaces, which means the tech arrives ready to repair rather than diagnose and reschedule. Same-day service is available throughout Santa Clarita, including Valencia, Canyon Country, Newhall, Saugus, and Stevenson Ranch. Call (661) 621-3712 early for the best same-day windows.
Is it cheaper to repair or replace my furnace?
Repair is cheaper in the short term, but the real question is whether the furnace is worth repairing. A good rule of thumb: if the repair cost exceeds 50% of the furnace’s replacement value and the unit is over 15 years old, replacement is usually the smarter money. We give you both numbers in writing and let you decide without pressure. Call (661) 621-3712 for an honest assessment.
Does Dalton Heating & Air guarantee furnace repairs?
Yes, every furnace repair is guaranteed in writing for a full 365 days. If the same repair fails within that year, we come back at no charge for the return visit or the re-repair. That’s the 365-Day Done Right Promise, and it’s automatic on every job, not an upsell. That’s The Garrison Standard applied to every call we run in Santa Clarita.
What furnace brands do you repair?
We service all nine major residential HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. If your furnace sits outside that list, call us anyway. Our techs are factory-trained on those nine and experienced with most others found in Santa Clarita homes. Reach us at (661) 621-3712 with your model number and we’ll confirm parts availability.
Can you come today if my furnace dies overnight?
Yes, our phones are answered by a live person 24/7, and we run emergency furnace repair calls throughout the Santa Clarita Valley. Overnight lows in the SCV can hit the mid-30s in winter, and we don’t consider a no-heat call something that can wait until morning. Call (661) 621-3712 and we’ll get a tech dispatched to you as soon as possible.
Why Santa Clarita Homeowners Call Dalton Heating & Air
The Santa Clarita Valley stretches from the 5 and 14 corridors through Valencia, Saugus, Canyon Country, Newhall, and up into Castaic. That means winter mornings are cold enough that a furnace failure on a Tuesday isn’t just an annoyance, it’s a disruption to your household. We’ve been doing this work under The Garrison Standard since 2003, and the terms never change: arrive inside the window, price in writing before starting, do the job by the book, leave the site clean, and stand behind the work for a full year.
Marco Benitez runs each call with a simple expectation: the homeowner knows who’s coming, what it will cost, and what happens if the repair doesn’t hold. Background-checked, uniformed techs on every call. A written guarantee on every repair. A live person on the phone at (661) 621-3712 at 2 p.m. or 2 a.m.
If your furnace is acting up, call (661) 621-3712 now for a free estimate. Whether it’s a quick flame sensor swap or a full diagnosis of a failing Goodman or Rheem unit, we’ll show you the price before we touch a single screw, and we’ll back the repair in writing for a full year.
Written by Marco Benitez, Owner at Dalton Heating & Air Santa Clarita, serving Santa Clarita.